It is useless to try to fix it on your own. QSS 32 and later with A1 or fF type – you can try to “reset” the laser.Įven if it helps for a while, in the end, you will still have to repair the laser module. ![]() QSS 30/31 with Type A laser – you can auto-tune. We recommend that you send us the defective laser module for upgrading to the SLD level or get a new SLD laser module. Using a laser at this level will very quickly shorten the life of the laser as it destroys all the internal elements of the laser module. Sometimes this can be erased by restarting the lab and the lab will run without any errors for a certain amount of time, but the appearance of this error means that a certain laser module is operating at a current that is VERY close to the maximum allowable limit. When such errors appear, first take corrective actions for each error. This error message can appear due to the following errors ![]() This error can occur if the current has reached the maximum limit. The code of the most serious and unpleasant error for the laboratory owner.
0 Comments
Leave a Reply. |